XRAY 50mm ECS Driveshaft w/2mm Pins

With the ECS drive shafts, wheel vibrations and noise are decreased to minimum, steering is increased and cornering speed and smoothness increases noticeable.

NOTE: To use the ECS drive shafts you need to use the front C-hubs V2 with the larger opening. The C-hubs V2 were included in all T2'008/T3/T4 kits, so owners of the T2, T2'007 and T2R must purchase the C-hubs V2 separately.

It is very important to regularly service the shafts in order to increase the lifespan and maintain performance.

Before use, these steps MUST be followed:
1. Assemble the ECS drive shaft.
2. Use #106210 HUDY Graphite Grease to lubricate both drive shaft couplings.
3. Use medium-grade thread lock (e.g., Loctite™ 242) on both setscrews. Do not use too much threadlock as
it may block the drive shaft.
4. Ensure that the ECS drive shaft moves freely.

Parts List:
XRA305226   ECS Drive Shaft 50mm for 2mm Pin - HUDY Spring Steel™
XRA305252   ECS Drive Shaft Case for 2mm Pin - HUDY Spring Steel™ 
XRA305253   ECS Drive Shaft Coupling for 2mm Pin - HUDY Spring Steel